Measurement Setup

1. Attach the shoelace mount to your footwear.

*For specialized shoes with a dedicated slot, place ORPHE CORE into the compartment under the insole.

Shoelace mount in place

1. Set the ORPHE CORE into the shoelace mount.

   IMG_0147.MOV

   

   Sensors set up on both feet

2. Launch the ORPHE TRACK app.

   

3. Allow access to location information as "Always." For Android, please also allow "Nearby devices.”

   

   

4. Tap “Sensor not connected” to connect the ORPHE CORE.

   

   

   <aside> 💡 If ORPHE CORE is not detected with Bluetooth on, shake the device to activate it. If it still doesn't appear, try charging it once - this should resolve the connection.

   </aside>

   IMG_0134.MOV

   

   If not connected to the app, the LED remains on until charging completes.

5. For instep mounting, tap “Setup calibration” to automatically adjust the measurement position.

   

   

Measurement

1. Begin measurement. Once started, measurement will continue even with your screen off. To carry your smartphone comfortably during the run, you can use a pouch like the one shown below.

   

   

   <aside> 💡

   With the ORPHE TRACK app, you can measure without carrying your smartphone. Note: location data won’t be recorded in this case.

   </aside>

2. End measurement. Bring the ORPHE CORE and smartphone close to each other. Data will be transferred from the ORPHE CORE to the app via Bluetooth.

   <aside> ⚠️

   Please wait for the log reading to complete. If the connection is interrupted, measurement data may not appear.

   </aside>

   <aside> 💡

   If you measure without carrying your smartphone, ORPHE CORE will start loading logs after reconnecting to the smartphone.

   </aside>

   

   • Once loading is complete, your measurement data will appear.
   • Note: These are preliminary results. The official measurement results will be displayed after the server synchronization is complete.

   <aside> ⚠️

   If you measure for a long time and record a large amount of data, it may take time to transfer data from the app to the server, which may cause a time lag before the measurement results are displayed.

   </aside>

   

   

Displaying Measurement Results

Your past measurement data will be displayed on the record screen.